Aqua Air Systems Ltd.

Alberta Toll Free: 1.800.461.3812

Edmonton Head Office
8703 50 St NW
Edmonton, AB • T6B 1E7
p 780.465.8011 • f 780.465.8919

Calgary Office
#2 12180 - 44 St. SE
Calgary, Alberta T2Z 4A2
p 403.279.7958 • f 587.352.9745

Aqua Air Energy Solutions
1090 Homer St.
Suite 332
Vancouver, BC V6B 2W9

 

Sterling Combustion

Sterling Combustion Inc. has been involved in the North American packaged boiler, burner and combustion industry since 1980. Our products and design engineering are based on the best available technology for reducing fuel usage and for complying with environmentally acceptable emission standards. Sterling Combustion boilers comply with ASME, National Board, CRN, UL, CUL, CSA, CGA, FM, IRI and NFPA codes.

For more information, visit http://www.sterlingcombustion.com.

Autoflame

Computerized combustion management systems: burner management and optimal fuel/air ratio control, exhaust gas analysis and trim, continuous emissions monitoring and control, data acquisition and control, intelligent boiler sequencing, boiler water-level control, steam flow metering, blow down management and control.

For more information, visit http://www.autoflame.com.


Limpsfield

Limpsfield Combustion is an industrial burner manufacturer, offering complete solutions to combustion requirements from standard burners to individually engineered solutions.

For more information, visit http://www.limpsfield.co.uk.



Fuel Master

Fuel Master burners are extremely versatile, and easily adapted to all types of firebox, scotch marine, cast iron, water tube and packaged boilers, indirect fired air heaters, incinerator ovens and other commercial and industrial applications.

For more information, visit http://www.fuelmaster.ca.


Creek Condensing Boilers

Creek boilers are specifically designed to deliver maximum total efficiency and lowest total emissions, while maintaining a respnsive load response low waterside pressure drop, for both the replacement heating boiler market and new construction.


These boilers are designed to fit through a standard doorway, with no tear down and re-assembly required for most retrofit applications.

.